Talk:NORD-10 Serial 619: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
mNo edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
: Card in slot 18 should be Panel Transceiver, PCB 1114. I do suspect an ATX power supply would be ok for one or two racks only if its the older ATX with 5V primary power. | : Card in slot 18 should be Panel Transceiver, PCB 1114. I do suspect an ATX power supply would be ok for one or two racks only if its the older ATX with 5V primary power. | ||
: Anyway, I think the panel transceiver might be a necessity if we are to get it running again. You need to check cards laying about, and I will prioritize getting one drawn upp in KiCAD just in case.. [[User:Roger|Roger]] ([[User talk:Roger|talk]]) 18:20, 1 May 2019 (UTC) | : Anyway, I think the panel transceiver might be a necessity if we are to get it running again. You need to check cards laying about, and I will prioritize getting one drawn upp in KiCAD just in case.. [[User:Roger|Roger]] ([[User talk:Roger|talk]]) 18:20, 1 May 2019 (UTC) | ||
:: Also card in slot 13 is most likely wrong, according to manuals the cache card, 1126, should be located in this slot. | |||
:: Backwiring on these slots should tell if my assumtions are correct however. -- [[User:Roger|Roger]] ([[User talk:Roger|talk]]) 19:07, 1 May 2019 (UTC) | |||
::: Regarding HAWK disk, card 1022 and 1122 is totally different, 1122 is 4x current loop terminal interface. [[User:Roger|Roger]] ([[User talk:Roger|talk]]) 13:03, 7 May 2019 (UTC) | |||
Latest revision as of 13:03, 7 May 2019
A PC power supply must be severely under-dimensioned I think? The ND power supplies I've seen have been 200A or 300A at +5V.. -- TArntsen (talk) 11:25, 1 May 2019 (UTC)
- Card in slot 18 should be Panel Transceiver, PCB 1114. I do suspect an ATX power supply would be ok for one or two racks only if its the older ATX with 5V primary power.
- Anyway, I think the panel transceiver might be a necessity if we are to get it running again. You need to check cards laying about, and I will prioritize getting one drawn upp in KiCAD just in case.. Roger (talk) 18:20, 1 May 2019 (UTC)