CHANGE-BIT-FILE - Revision history

Tingo: added example

2017-09-28T13:26:16Z

added example

← Older revision		Revision as of 13:26, 28 September 2017
Line 8:		Line 8:
	#The subcommands must follow the rules given in @LOOK-AT, rule 3. Terminate subcommands with a full stop (.).		#The subcommands must follow the rules given in @LOOK-AT, rule 3. Terminate subcommands with a full stop (.).
	#The bit file is divided into 20 (octal) word blocks. <address> in subcommands is relative address within block 0 - 17 (octal).		#The bit file is divided into 20 (octal) word blocks. <address> in subcommands is relative address within block 0 - 17 (octal).

			Example:
			@CHANGE-BIT-FILE P-ONE, 5
			5/1777777 157777
			2000 .
			@

	== Related commands ==		== Related commands ==

Tingo: created CHANGE-BIT-FILE page

2017-09-28T13:23:35Z

created CHANGE-BIT-FILE page

New page

@CHANGE-BIT-FILE <directory name>, <block no.>
Change a block in the bit file of a directory.
; <directory name> : directory.
; <block no.> : See rule 3 below.

Rules:
#Permitted only for user SYSTEM.
#The subcommands must follow the rules given in @LOOK-AT, rule 3. Terminate subcommands with a full stop (.).
#The bit file is divided into 20 (octal) word blocks. <address> in subcommands is relative address within block 0 - 17 (octal).

== Related commands ==
@[[DUMP-BIT-FILE]]

== References ==
{{ND-doc|60.128.03}} (printed February 1983), page 1-30

{{ND-doc|60.174.Q01}}
<references/>
[[Category:System Commands]]