Tingo: created page for the ENTER-DIRECTORY command

2013-12-21T21:51:48Z

created page for the ENTER-DIRECTORY command

New page

@ENTER-DIRECTORY <directory name>, <device name>, [<unit>], [<'F' or 'R'>], [<subunit>]
Enter a directory on a mounted device when mounted. This must be done before files can be accessed.
; <directory name> : default is the directory name created on the device by the @CREATE-DIRECTORY command.
; <device name> : the name of the mass storage device controller on which the device unit is connected. See {{ND-doc|60.128.01}} Appendix F for legal names.
; <unit> : the unit number. Only to be specified if [[SINTRAN III]] is generated with multiple units. Unit number starts at 0 (zero) octal, default is 0 (zero).
; <'F' or 'R'> : F = a fixed cartridge disk pack. R = a removable cartridge disk pack. Otherwise, the parameter is not used.
; <subunit> : applies only to big cartridge disk.
Rules:
#Permitted for all users.
#Valid only if <directory name> matches or is an abbreviation of the name found on the device (see @CREATE-DIRECTORY).

Example:

@ENTER-DIRECTORY PACK-ONE, DISC-10MB-1, 1, F

A directory by the name of PACK-ONE is entered on device DISC-10MB-1, unit 1, fixed pack.

== Related commands ==
@[[CREATE-DIRECTORY]]

@[[SET-DEFAULT-DIRECTORY]]

@[[RELEASE-DIRECTORY]]

== References ==
{{ND-doc|60.128.01}} (printed June 1980), pages 1-71, 1-72

{{ND-doc|60.174.Q01}}
[[Category:Background Commands]]

ENTER-DIRECTORY - Revision history

Tingo: created page for the ENTER-DIRECTORY command