3027: Difference between revisions
Jump to navigation
Jump to search
(created the page) |
(added a "see also" section) |
||
| Line 18: | Line 18: | ||
==I/O Devices on the card== | ==I/O Devices on the card== | ||
not described yet. | not described yet. | ||
==See also== | |||
*[[3106]] | |||
*[[3112]] | |||
==Reference== | ==Reference== | ||
{{ND-doc|06.015.02}} | {{ND-doc|06.015.02}} | ||
[[Category:ND-100 hardware]] | [[Category:ND-100 hardware]] | ||
Revision as of 20:01, 21 September 2012
3027 is the Floppy disk controller for DMA.
 |
This article is a stub. You can improve NDWiki by expanding it. |
Introduction
A floppy controller for 8 inch floppy drives.
Switches and indicators
From top of the card
A three digits error code display. After Master Clear, the floppy controller will start a selftest. If successful, 000 will be shown, else an error code is displayed here. During transfer 000 is normally displayed. If an error occurs, and "E" with an error code is displayed.
A device number thumbwheel switch
- 0 - floppy disk system no 1 - device number 1560 (octal) - Ident = 21
- 1 - floppy disk system no 2 - device number 1570 (octal) - Ident = 22
Setting 2-15 are unused, will answer on IOX 0-7.
Connectors
The A and B connectors are used for I/O, the C connector is used for the ND-100 Bus.
I/O Devices on the card
not described yet.
See also
Reference
Norsk Data Document ND–06.015.02 ND-100 FUNCTIONAL DESCRIPTION