STOP-SYSTEM

From NDWiki
Revision as of 10:57, 22 September 2017 by Tingo (talk | contribs) (added missing information)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
@STOP-SYSTEM

Stop the system. This command can not be abbreviated.

Rules:

  1. Permitted only for user SYSTEM.
  2. All hardware registers are saved before the system goes into stop mode.
  3. The system can be restarted by pressing the RESTART button on a NORD-10 (20! on ND-100) on the operator's panel. On restart logged in users can continue their programs. No start up procedure is necessary and no information is lost.
  4. To turn off the system for a longer period:
    1. Log out all users (preferably)
    2. Press STOP and MASTER CLEAR on operator's panel.
    3. Stop the disk only if temperature, energy and/or noise conditions require it. The system should normally be left running, even over night. It should only be turned off for hardware maintenance, etc.

Related commands

References

Norsk Data Document ND–60.128.03 SINTRAN III REFERENCE MANUAL (printed February 1983), page 1-210

Norsk Data Document ND–60.174.Q01 SINTRAN III QUICK REFERENCE CARD